Link Aggregation Control Protocol Configuration - HP 10GB ETHERNET BL-C SWITCH BMD00022 Command Reference Manual

Link Aggregation Control Protocol configuration

Command: /cfg/l2/lacp
[LACP Menu]
The following table describes the LACP Configuration Menu options.
Table 120
LACP Configuration Menu options
Command
sysprio <1-65535>
timeout short|long
port <port number>
cur
LACP Port configuration
Command: /cfg/l2/lacp/port <port number>
[LACP Port 2 Menu]
The following table describes the LACP Port Configuration Menu options.
Table 121
LACP Port Configuration Menu options
Command
mode off|active|passive
prio <1-65535>
sysprio - Set LACP system priority
timeout - Set LACP system timeout scale for timing out partner info
port - LACP port Menu
cur - Display current LACP configuration
Description
Defines the priority value (1 through 65535) for the switch. Lower numbers
provide higher priority. The default value is 32768.
Defines the timeout period before invalidating LACP data from a remote
partner. Choose short (3 seconds) or long (90 seconds). The default
value is long.
HP recommends that you use a timeout value of long, to reduce LACPDU
processing. If your switch's CPU utilization rate remains at 100% for periods
of 90 seconds or more, consider using static trunks instead of LACP.
Displays the LACP Port menu.
Display current LACP configuration.
mode - Set LACP mode
prio - Set LACP port priority
adminkey - Set LACP port admin key
cur - Display current LACP port configuration
Description
Set the LACP mode for this port, as follows:
•
off—Turn LACP off for this port. You can use this port to manually
configure a static trunk. The default value is off.
•
active—Turn LACP on and set this port to active. Active ports initiate
LACPDUs.
•
passive—Turn LACP on and set this port to passive. Passive ports do
not initiate LACPDUs, but respond to LACPDUs from active ports.
Sets the priority value for the selected port. Lower numbers provide higher
priority. The default is 128.
Configuration Menu 151