Ip Trunk Hash Configuration - HP 10GB ETHERNET BL-C SWITCH BMD00022 Command Reference Manual

IP Trunk Hash configuration

Command: /cfg/l2/thash
[IP Trunk Hash Menu]
The following table describes the IP Trunk Hash Configuration Menu options.
Table 118
IP Trunk Hash Configuration Menu options
Command
set
cur
Layer 2 IP Trunk Hash configuration
Command: /cfg/l2/thash/set
[set IP Trunk Hash Settings Menu]
Trunk hash parameters are set globally for the HP 10GbE switch. You can enable one or two
parameters, to configure any of the following valid combinations:
•
SMAC (source MAC only)
•
DMAC (destination MAC only)
•
SIP (source IP only)
•
DIP (destination IP only)
•
SIP + DIP (source IP and destination IP)
•
SMAC + DMAC (source MAC and destination MAC)
The following table describes the IP Trunk Hash Configuration Menu options.
Table 119
IP Trunk Hash Set Menu options
Command
smac enable|disable
dmac enable|disable
sip enable|disable
dip enable|disable
cur
set - IP Trunk Hash Settings Menu
cur - Display current IP trunk hash configuration
smac - Enable/disable smac hash
dmac - Enable/disable dmac hash
sip - Enable/disable sip hash
dip - Enable/disable dip hash
cur - Display current trunk hash setting
Description
Displays the Trunk Hash Settings menu.
Display current trunk hash configuration.
Description
Enable or disable trunk hashing on the source MAC.
Enable or disable trunk hashing on the destination MAC.
Enable or disable trunk hashing on the source IP.
Enable or disable trunk hashing on the destination IP.
Display current trunk hash configuration.
Configuration Menu 150