Table of Contents
Advertisement
The following table describes the BOOTP Configuration Menu options.
Table 158
BOOTP Configuration Menu options
Command
addr <IP address>
addr2 <IP address>
on
off
cur
Server Mobility configuration
Command: /cfg/l3/sm
[ServerMobility Menu]
The following table describes the Server Mobility Configuration menu options.
Table 159
Server Mobility Configuration menu options
Command
port <port number>
default
add <port number>
rem <port number>
filter enable|disable
nsmrelay enable|disable
on
off
cur
Description
Sets the IP address of the BOOTP server. For example, 100.10.1.1.
Sets the IP address of the secondary BOOTP server. For example,
100.10.1.2.
Globally turns on BOOTP relay.
Globally turns on BOOTP relay.
Displays the current BOOTP relay configuration.
port
- Server Mobility Port Menu
default
- Set ServerMobility configuration to factory default
add
- Add ServerMobility ports
rem
- Remove ServerMobility ports
filter
- Enable/Disable DHCP request message filters on ports
nsmrelay - Enable/Disable relay on non-ServerMobility ports
on
- Globally turn ServerMobility ON
off
- Globally turn ServerMobility OFF
cur
- Display current ServerMobility configuration
Description
Displays the Server Mobility port menu.
Resets the Server Mobility parameters to their factory default values.
Configures a port as a Server Mobility port.
Removes the port from Server Mobility.
Enables or disables filtering DHCP request information on the port.
When enabled, DHCP requests from the server are filtered, so that
the DHCP server receives only DHCP requests from the
HP 1:10 GbE switch.
Enables or disables BOOTP Relay for all ports that have Server
Mobility disabled. The default value is disabled.
Globally turns Server Mobility on.
Globally turns Server Mobility off.
Displays the current Server Mobility settings.
Configuration Menu 181
Advertisement
Table of Contents
