Default Gateway Configuration - HP 10GB ETHERNET BL-C SWITCH BMD00022 Command Reference Manual

Hewlett-packard switch user manual
Table of Contents

Advertisement

Default Gateway configuration

Command: /cfg/l3/gw <1-4, 254>
[Default gateway 1 Menu]
The switch supports up to four gateways, plus the management gateway 254. By default,
no gateways are configured on the switch. Enter 1, 2, 3, or 4, or 254 in the command as the
<gateway number>, depending upon which gateway you want to configure.
The following table describes the Default IP Gateway Configuration Menu options.
Table 131
Default IP Gateway Configuration Menu options
Command
addr <IP address>
intr <0-60>
retry <1-120>
arp disable|enable
ena
dis
del
cur
addr
- Set IP address
intr
- Set interval between ping attempts
retry
- Set number of failed attempts to declare gateway DOWN
arp
- Enable/disable ARP only health checks
ena
- Enable default gateway
dis
- Disable default gateway
del
- Delete default gateway
cur
- Display current default gateway configuration
Description
Configures the IP address of the default IP gateway using dotted decimal notation.
For example, 192.4.17.44.
The switch pings the default gateway to verify that it is up. The intr option sets
the time between health checks. The range is from 0 to 60 seconds. The default is
2 seconds.
Sets the number of failed health check attempts required before declaring this
default gateway inoperative. The range is from 1 to 120 attempts. The default is 8
attempts.
Enables or disables Address Resolution Protocol (ARP) health checks. This
command is disabled by default.
Enables the gateway for use.
Disables the gateway.
Deletes the gateway from the configuration.
Displays the current gateway settings.
Configuration Menu 160

Advertisement

Table of Contents
loading

This manual is also suitable for:

10gb ethernet bl-c

Table of Contents