Acl Ip Version 4 Filter Configuration - HP 10GB ETHERNET BL-C SWITCH BMD00022 Command Reference Manual

ACL IP Version 4 Filter configuration

Command: /cfg/acl/acl <1-384>/ipv4
[Filtering IPv4 Menu]
This menu allows you to define IPv4 matching criteria for an ACL. The following table describes the IP
version 4 Filter Configuration Menu options.
Table 173
IPv4 Filter Configuration Menu options
Command
sip <IP address> <IP mask>
dip <IP address> <IP mask>
proto <0-255>
tos <0-255>
reset
cur
sip - Set to filter on source IP address
dip - Set to filter on destination IP address
proto - Set to filter on protocol
tos - Set to filter on TOS
reset - Reset all fields
cur - Display current parameters
Description
Defines a source IP address for the ACL. If defined, traffic with this
source IP address will match this ACL. Specify an IP address in dotted
decimal notation. For example, 100.10.1.1.
Defines a destination IP address for the ACL. If defined, traffic with this
destination IP address will match this ACL. For example, 100.10.1.2.
Defines an IP protocol for the ACL. If defined, traffic from the specified
protocol matches this filter. Specify the protocol number. Some of the
well-known protocols include:
•
1—icmp
•
2—igmp
•
6—tcp
•
17—udp
•
89—ospf
•
112—vrrp
Defines a Type of Service value for the ACL. For more information on
ToS, see RFC 1340 and 1349.
Resets the IPv4 parameters for the ACL to their default values.
Displays the current IPV4 parameters.
Configuration Menu 193