Operator Mode; Machine Identification - Aristocrat USA MAV500/MKVI Service Manual

Machine Modes

3.3 Operator Mode

Operator Mode addresses the jurisdictional and accounting / management information
requirements, allows the machine configuration to be changed, and facilitates
machine testing and fault finding. Entry to Operator Mode is achieved by turning the
Audit (Operator) key ON. The various options can be selected by following the on-
screen guidance and pressing the appropriate pushbutton.
The Operator Mode structure is shown in Figure 3-5 and the Operator Mode Menu
screen is shown below
Instructions are given on each screen to guide the operator through the various menus
and options available. Any active lockups (tilts) are indicated by a flashing message
at the bottom of the screen.
3-12
This document contains confidential information which is proprietary to ATI. It may not be disclosed to any unauthorized parties,
and it may not be copied. All rights reserved. © Copyright (ATI) Aristocrat Technologies, Inc. 2002.
Note
The screen displays and options covered in
this chapter are typical; however, slight
variations may occur between markets.
OPERATOR MODE MENU
1

Machine Identification

2 Accounting Information
3 Diagnostic Information
4 Test/Diagnostics Information
5 Operator Setup/Selections
6 Miscellaneous
7 Current Lockup
Service – Press to select next item
Cashout/TakeWin – Press to select previous item
Play 15 Lines – Press to choose selected item
Bet 10 Credits – Press to return to previous menu
Audit key – Turn off to exit
Note
"Audit key - Turn off to exit" message will not
be displayed if a Lockup is present.
USA MAV500/MKVI Service Manual
28-00486-00