Monitor Mask; Coin Tray - Aristocrat USA MAV500/MKVI Service Manual

USA MAV500/MKVI Service Manual

Monitor Mask

The monitor mask is molded from high-strength plastic. The mask and a foam tape
gasket match the contour of the monitor to provide a protective seal against moisture
and intrusion.
The mask is held in position by screws at the top and by the mid trim panel at the
bottom.
Removal and Replacement Procedures:
To remove the monitor mask:
1. Open the cabinet door, and switch OFF the machine.
2. Remove the screws from the top of the mask.
3. Gently ease the monitor mask up and out of the door.
Replacement is a reversal of the removal procedure.

Coin Tray

The coin tray provides a receptacle for coins or tokens that are dispensed by the
machine hopper, and also for coins or tokens that are rejected by the coin handling
system. The tray mounts onto the lower section of the door and is held in position
with six screws. Four screws are inserted from the inside of the door, and two screws
are inserted from the front after opening the belly panel door. It consists of three
components that are held together by locating tabs. The mounting screws must be
removed before the coin tray can be disassembled.
Removal, Disassembly, and Replacement Procedures:
To remove the coin tray from the machine (refer to Figure 4-8):
1. Open the cabinet door, and switch OFF the machine.
2. Remove the six screws that secure the coin tray to the door.
3. Gently pull the coin tray assembly from the door.
4. The end caps can be removed from the chip tray by pressing the front panel of
the chip tray in until the locating tabs disengage.
Replacement is a reversal of the removal procedure. When replacing the coin tray,
the location tabs should be aligned with the corresponding slots on the bottom of the
cabinet door.
28-00486-00
This document contains confidential information which is proprietary to ATI. It may not be disclosed to any unauthorized parties,
and it may not be copied. All rights reserved. © Copyright (ATI) Aristocrat Technologies, Inc. 2002.
Cabinet, Door and Top Box
4-17