Aristocrat USA MAV500/MKVI Service Manual page 193

USA MAV500/MKVI Service Manual
VFM4 Hexadecimal Messages
9.2 Installation and Machine Conditions
9.2.1 Configuration Setup
Bill Acceptor configuration options are established by the use of DIP switches and
the Operator Mode Menu settings. To enable bill denominations, it is necessary to set
the required bill values in both the bill acceptor DIP switches and the Operator Mode
menu options.
The DIP switches are conveniently located at the top of the bill acceptor housing.
The main function of the DIP switches is to set the accepted bill denominations.
The settings for accepted bill denominations are found in the Operator Mode Menu
⇒ Operator Setup / Selections Menu ⇒ Machine Options (refer to the chapter
Machine Modes for more information).
A panel, located at the bill entry channel on the mid trim, identifies the accepted bill
denominations (see Figure 9-8).
28-00486-00
This document contains confidential information which is proprietary to ATI. It may not be disclosed to any unauthorized parties,
and it may not be copied. All rights reserved. © Copyright (ATI) Aristocrat Technologies, Inc. 2002.
VFM4 HEX CODE MESSAGES
$1 CREDIT
$ 5 CREDIT
$ 10 CREDIT
$ 20 CREDIT
$ 50 CREDIT
$ 100 CREDIT
VEND
RETURNED
REJECT
FAILURE
STACKER FULL
STACKER REMOVED
STACKER ATTACHED
Figure 9-7 VFM4 Protocol - Hex Code Messages
81H
83H
84H
85H
86H
87H
89H
8AH
8BH
8CH
8DH
8EH
8FH
Bill Acceptor
9-13