Commissioning The Machine - Aristocrat USA MAV500/MKVI Service Manual

USA MAV500/MKVI Service Manual
c. Should color aberrations persist, use a degaussing coil to degauss the
monitor and cabinet.

2.3.3 Commissioning the Machine

Carry out the following procedures to commission the machine:
1. Check that the machine program type and variation match the customer order.
Use the Operator Mode menu and the options described in the chapter Machine
Modes.
2. If the machine is fitted with a hopper, fill the hopper as described below.
The procedure for filling the hopper is dependent on house rules.
a. Obtain the correct number of coins required to fill the hopper.
b. Open the cabinet door. If the jurisdiction requires that the hopper be
weighed, turn OFF the machine before removing the hopper.
c. Place the coins in the hopper, and close and lock the cabinet door.
d. Record the number of coins placed in the hopper in the refill register.
3. Where the Operator permits, monitor gameplay operations for any faults:
a. For machines that accept bills, coupons, or bank notes, insert a valid bank
note (in good condition) and confirm that it is accepted and credited
correctly. If the bank note is not accepted on the second attempt, repeat
the test on another note. If the second bank note is also rejected, refer to
the Fault Finding section in the Bank Note Acceptor chapter of the
Service Manual.
b. For machines that accept coins, check that coins are accepted, credited,
and paid out correctly.
Retrieve bank notes and coins inserted during testing.
4. Machines operating on a network system may now be connected and installed
onto the network. For installation procedure refer to the manual for the
particular communications network used.
5. For machines fitted with a ticket printer, carry out the general maintenance
procedures as detailed in the Printer chapter of the Service Manual or the Care
and General Maintenance chapter of the Operator Manual.
6. Request an Operator to record the values of the hard audit meters (if fitted) and
the soft audit meters (as required by the applicable jurisdictional authority).
7. Log installation data as specified by the appropriate jurisdictional requirements.
The machine may now be placed in service pending appropriate jurisdictional
approval.
28-00486-00
This document contains confidential information which is proprietary to ATI. It may not be disclosed to any unauthorized parties,
and it may not be copied. All rights reserved. © Copyright (ATI) Aristocrat Technologies, Inc. 2002.
Important Note
Installation
2-9