Cp133S Coin Validator Connector Pinouts - Aristocrat USA MAV500/MKVI Service Manual

Coin Chute Assembly
Replacing the Divider Piece and the Gate Piece
Ensuring the coin deflector piece is in place, if one was fitted, hold the gate piece
•
and the divider piece flush with each other.
Position them at a 45° angle from the left-hand side (refer to Figure 6-11), align
•
the plastic stud on the left-hand side of the divider piece with the hole on the left-
hand side of the body.
Twist the divider piece and the gate piece together to the left, ensuring the plastic
•
stud goes into the hole in the body.
Press down on the divider cover until the divider piece clicks into place within the
•
body.
Re-insert the metal ring into the body, if one was fitted. Insert the screw and
•
tighten with a torque screwdriver to 47 inch-oz.
Now re-insert the connectors into their relevant polarized positions.
•
Ensure the pin on
the divider section
goes into the hole
in the main body
Figure 6-11 Replacing the Gate Piece and the Divider Piece

6.3.4 CP133S Coin Validator Connector Pinouts

The connector J1 on the right of the validator connects to P14 on the Interface Board.
The coin interface section of the I/O Driver Board receives the signals from the coin
validator and solenoid optics and converts them into the form required by the Main
Board. For a description of the coin-handling interface refer to the I/O Driver Board
chapter. The signals to and from the coin validator are shown in the following table.
6-18
This document contains confidential information which is proprietary to ATI. It may not be disclosed to any unauthorized parties,
and it may not be copied. All rights reserved. © Copyright (ATI) Aristocrat Technologies, Inc. 2002.
USA MAV500/MKVI Service Manual
Gate
Piece
Twist to
the left
Divider
Piece
28-00486-00