USA MAV500/MKVI Service Manual
Cleaning the solenoid
Check the solenoid for any fluid residue and freedom of movement, and that the
•
pole piece does not stick inside the solenoid. Refer to Figure 6-10.
If residue is present, remove the solenoid screw. Refer to Figure 6-7.
•
Gently lift the solenoid clear of the body.
•
On standard solenoids the pole piece can be easily lifted out of the solenoid and
•
cleaned.
On reverse action solenoids, the circlip must be removed from the pole piece
•
before removing the pole piece.
Moisten a cotton bud with the cleaning fluid, and remove all the residue. Check
•
that the solenoid has freedom of movement.
Re-insert the pole piece and spring back into the solenoid and replace the circlip if
•
one was removed. Lifting the accept gate spring out of the way, re-insert the
solenoid into the divider piece, and re-insert the screw, and tighten with a torque
screwdriver to 47 inch-oz.
28-00486-00
This document contains confidential information which is proprietary to ATI. It may not be disclosed to any unauthorized parties,
and it may not be copied. All rights reserved. © Copyright (ATI) Aristocrat Technologies, Inc. 2002.
Figure 6-10 Solenoid Pole Piece
Coin Chute Assembly
SOLENOID
POLE
PIECE
6-17