Internal Error Codes - Cisco SPA1112 Provisioning Manual

Provisioning Parameters

Internal Error Codes

Internal Error Codes
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters
Parameter Name
UID1
UID2
ISCUST
The ATA defines a number of internal error codes (X00–X99) to facilitate
configuration in providing finer control over the behavior of the unit under certain
error conditions.
Parameter Name
X00
X20
X40
X60
Description and Default Value
The contents of the Line 1 User_ID configuration
parameter (Firmware 2.0. 1 1 and above).
The contents of the Line 2 User_ID configuration
parameter (Firmware 2.0. 1 1 and above).
Value=1 if unit is customized, 0 otherwise;
customization status viewable on WebUI Info page.
Description and Default Value
Transport layer (or ICMP) error when sending a SIP
request.
SIP request times out while waiting for a response.
General SIP protocol error (for example, unacceptable
codec in SDP in 200 and ACK messages, or times out
while waiting for ACK).
Dialed number invalid according to given dial plan.
5
80