Cisco SPA1112 Provisioning Manual page 140

Voice Parameters
<Feature_Dial_Services_Code>s
<Service_Annc_Base_Number>
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters
These codes tell the ATA what to do when the user is listening
to the first or second dial tone.
One or more *codes can be configured into this parameter,
such as *72, or *72|*74|*67|*82, etc. The maximum length is 79
characters. This parameter applies when the user has a dial
tone (first or second dial tone) After receiving dial tone, a user
enters the *code and the target number according to current
dial plan. For example, after user dials *72, the ATA plays a
special tone called a Prompt tone while awaiting the user to
enter a valid target number. When a complete number is
entered, the ATA sends a INVITE to *72 target_number as in a
normal call. This feature allows the proxy to process features
like call forward (*72) or Block Caller ID (*67)
The *codes should not conflict with any of the other vertical
service codes internally processed by the ATA. You can
remove a corresponding *code that you do not want to the
ATA to process.
You can add a parameter to indicate which tone plays after
the *code is entered, such as *72'c'|*67'p'. Below is a list of
allowed tone parameters (note the use of open quotes
surrounding the parameter, without spaces)
'c' = <Cfwd Dial Tone>
'd' = <Dial Tone>
'm' = <MWI Dial Tone>
'o' = <Outside Dial Tone>
'p' = <Prompt Dial Tone>
's' = <Second Dial Tone>
'x' = No tones are place, x is any digit not used above
If no tone parameter is specified, the ATA plays Prompt tone
by default. If the *code is not to be followed by a phone
number, such as *73 to cancel call forwarding, do not include
this parameter. Instead, add the *code in the dial plan and the
ATA send INVITE *73@..... as usual when user dials *73.
Default setting: blank
Base number for service announcements.
Default setting: blank
6
140