Cisco SPA1112 Provisioning Manual page 119

Voice Parameters
<Refer_Target_Bye_Delay_1_> through
<Refer_Target_Bye_Delay_5_>
<Referee_Bye_Delay_1_> through
<Referee_Bye_Delay_5_>
<Refer-To_Target_Contact_1_> through
<Refer-To_Target_Contact_5_>
<Sticky_183_1_> through <Sticky_183_
5_>
<Auth_INVITE_1_> through <Auth_
INVITE_5_>
<Reply_182_On_Call_Waiting_1_>
through <Reply_182_On_Call_Waiting_
5_>
<Use_Anonymous_With_RPID_1_>
through <Use_Anonymous_With_RPID_
5_>
<Use_Local_Addr_In_From_1_> through
<Use_Local_Addr_In_From_5_>
<Dial_Plan_1_3_> through <Dial_Plan_8_
3_>
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters
The number of seconds to wait before sending a BYE to the
refer target to terminate a stale call leg after a call transfer.
The number of seconds to wait before sending a BYE to the
referee to terminate a stale call leg after a call transfer.
To contact the refer-to target, select yes. Otherwise, select no.
Default setting: no
If this feature is enabled, the ATA ignores further 180 SIP
responses after receiving the first 183 SIP response for an
outbound INVITE. To enable this feature, select yes.
Otherwise, select no.
Default setting: no
When enabled, authorization is required for initial incoming
INVITE requests from the SIP proxy.
Default setting: no
When enabled, the ATA replies with a SIP182 response to the
caller if it is already in a call and the line is off-hook. To use this
feature select yes.
Default setting: no
Determines whether or not the ATA uses "Anonymous" when
Remote Party ID is requested in the SIP message.
Default setting: yes
Use the local ATA IP address in the SIP FROM message.
Default setting: no
The PSTN dial plan pool. You can associate a dial plan with a
VoIP Caller or a PSTN Caller by referencing the index number
(1~8).
Default setting: (xx.)
6
119