Cisco SPA1112 Provisioning Manual page 130

Voice Parameters
<Reorder_Tone>
<Off_Hook_Warning_Tone>
<Ring_Back_Tone>
<Ring_Back_2_Tone>
<Confirm_Tone>
<SIT1_Tone> through <SIT4_Tone>
<MWI_Dial_Tone>
<Cfwd_Dial_Tone_>
<Holding_Tone>
<Conference_Tone>
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters
Played when an outbound call has failed, or after the far end
hangs up during an established call. Reorder Tone is played
automatically when Dial Tone or any of its alternatives times
out.
Default setting: 480@-5,620@-5;10(.25/.25/1+2)
Played when the caller has not properly placed the handset
on the cradle. Off Hook Warning Tone is played when the
Reorder Tone times out.
Default setting: 480@-3,620@3;10(. 1 25/. 1 25/1+2)
Played during an outbound call when the far end is ringing.
Default setting: 440@-5,480@-5;*(2/4/1+2)
Your ATA plays this ringback tone instead of Ring Back Tone if
the called party replies with a SIP 182 response without SDP
to its outbound INVITE request.
Default setting: the same as Ring Back Tone, except the
cadence is 1s on and 1s off.
Default setting: 440@-5,480@-5;*(1/1/1+2)
Brief tone to notify the user that the last input value has been
accepted.
Default setting: 600@-4;1(.25/.25/1)
Alternative to the Reorder Tone played when an error occurs
as a caller makes an outbound call. The RSC to trigger this
tone is configurable on the SIP screen.
Default setting: 985@-4,1428@-4,1777@-4;20(.380/0/1,.380/
0/2,.380/0/3,0/4/0)
Played instead of the Dial Tone when there are unheard
messages in the caller's mailbox.
Default setting: 350@-5,440@-5;2(. 1 /. 1 /1+2);10(*/0/1+2)
Played when all calls are forwarded.
Default setting: 350@-5,440@-5;2(.2/.2/1+2);10(*/0/1+2)
Informs the local caller that the far end has placed the call on
hold.
Default setting: 600@-5;*(. 1 /. 1 /1,. 1 /. 1 /1,. 1 /9.5/1)
Played to all parties when a three-way conference call is in
progress.
Default setting: 350@-5;20(. 1 /. 1 /1,. 1 /9.7/1)
6
130