Cisco SPA1112 Provisioning Manual page 82

Voice Parameters
<Syslog_Server>
<Debug_Server>
<Debug_Level>
<Provision_Enable>
<Resync_On_Reset>
<Resync_Random_Delay>
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters
Specify the syslog server name and port. This feature
specifies the server for logging ATA system information and
critical events. If both Debug Server and Syslog Server are
specified, Syslog messages are also logged to the Debug
Server.
Default setting: blank
The debug server name and port. This feature specifies the
server for logging debug information. The level of detailed
output depends on the debug level parameter setting.
Default setting: blank
Determines the level of debug information that will be
generated. Select 0, 1, 2, 3 or 3+Router from the drop-down
list. The higher the debug level, the more debug information
will be generated. Level 0 means that no information will be
collected. Levels 1, 2 & 3 generate messages related to the
voice ports only. Level 3+Router generates debug content for
both voice and router components.
Default setting: 3
Controls all resync actions independently of firmware
upgrade actions. Set to yes to enable remote provisioning.
Default setting: yes
Triggers a resync after every reboot except for reboots
caused by parameter updates and firmware upgrades.
Default setting: yes
The maximum value for a random time interval that the ATA
waits before making its initial contact with the provisioning
server. This delay is effective only on the initial configuration
attempt following power-on or reset. The delay is a pseudo-
random number between zero and this value.
This parameter is in units of 20 seconds; the default value of 2
represents 40 seconds. This feature is disabled when this
parameter is set to zero.
This feature can be used to prevent an overload of the
provisioning server when a large number of devices power-
on simultaneously.
Default setting: 2 (40 seconds)
6
82