Cisco SPA1112 Provisioning Manual page 98

Voice Parameters
<Blind_Attn-Xfer_Enable_1_>
<Blind_Attn-Xfer_Enable_2_>
<MOH_Server_1_>
<MOH_Server_2_>
<Xfer_When_Hangup_Conf_1_>
<Xfer_When_Hangup_Conf_2_>
<Conference_Bridge_URL_1_>
<Conference_Bridge_URL_2_>
<Conference_Bridge_Ports_1_>
<Conference_Bridge_Ports_2_>
<Enable_IP_Dialing_1_>
<Enable_IP_Dialing_2_>
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters
Enables the ATA to perform an attended transfer operation by
ending the current call leg and performing a blind transfer of
the other call leg. If this feature is disabled, the ATA performs
an attended transfer operation by referring the other call leg
to the current call leg while maintaining both call legs. To use
this feature, select yes. Otherwise, select no.
Default setting: no
User ID or URL of the auto-answering streaming audio server.
When only a user ID is specified, the current or outbound
proxy is contacted. Music-on-hold is disabled if the MOH
Server is not specified.
Default setting: blank
Makes the ATA perform a transfer when a conference call has
ended. Select yes or no from the drop-down menu.
Default setting: yes
This feature supports external conference bridging for n-way
conference calls (n>2), instead of mixing audio locally. To use
this feature, set this parameter to that of the server's name. For
example: conf@mysefver.com:12345 or conf (which uses
the Proxy value as the domain).
Default setting: blank
Select the maximum number of conference call participants.
The range is 3 to 10.
Default setting: 3
Enable or disable IP dialing. If IP dialing is enabled, one can
dial [userid@] a.b.c.d[:port], where '@', '.', and ':' are dialed by
entering *, user-id must be numeric (like a phone number) and
a, b, c, d must be between 0 and 255, and port must be larger
than 255. If port is not given, 5060 is used. Port and User-Id
are optional. If the user-id portion matches a pattern in the dial
plan, then it is interpreted as a regular phone number
according to the dial plan. The INVITE message, however, is
still sent to the outbound proxy if it is enabled.
Default setting: no
6
98