Cisco SPA1112 Provisioning Manual page 96

Voice Parameters
<Key_System_IP_Address>
<Force_LAN_Codec>
<Line_Enable_1_>
<Line_Enable_2_>
<Line_Enable_5_> through <Line_
Enable_13_>
<SAS_Enable_1_>
<SAS_Enable_2_>
<SAS_DLG_Refresh_Intvl_1_>
<SAS_DLG_Refresh_Intvl_2_>
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters
The IP address of the Cisco SPA9000.
Default setting: blank
If needed, specify a voice codec.
Default setting: none
To enable this line for service, select yes. Otherwise, select
no.
Default setting: yes
To enable the use of the line as a streaming audio source,
select yes. Otherwise, select no. If enabled, the line cannot be
used for outgoing calls. Instead, it auto-answers incoming
calls and streams audio RTP packets to the caller.
Default setting: no
If this value is not zero, it is the interval at which the streaming
audio server sends out session refresh (SIP re-INVITE)
messages to determine whether the connection to the caller
is still active. If the caller does not respond to the refresh
message, the ATA ends this call with a SIP BYE message. The
range is 0 to 255 seconds (0 means that the session refresh is
disabled)
Default setting: 30
6
96