Cisco SPA1112 Provisioning Manual page 123

Voice Parameters
<PSTN_PIN_Max_Retry_3_>
<PSTN_CID_for_VoIP_CID_3_>
<PSTN_CID_Number_Prefix_3_>
<PSTN_Caller_Default_DP_3_>
<Line_1_Signal_Hook_Flash_to_PSTN_
3_>
<PSTN_CID_Name_Prefix_3_>
<PSTN_Caller_ID_Pattern_3_>
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters
The number of times that a PSTN caller can attempt to enter a
PIN number, if the authentication method is set to PIN.
Default setting: 3
Choose yes or no.
Default setting: no
A dialing prefix, if needed, to add to the caller ID number on
the PBX to ensure that a callback goes to the correct number.
Default setting: blank
The index number of the dial plan that is used when the PSTN
Caller Auth Method is set to none.
Default settings: 1
Specify the operation of the hook flash on the analog phone
when a PSTN-to-VoIP call is active. Choose Disabled or
Double Hook Flash.
Default setting: Disabled
The prefix to add to the caller ID name that is sent to the PBX.
Enter the characters to add to the caller ID name.
Default setting: blank
A comma-separated list of phone number patterns that is
used to allow or block access to the VoIP gateway based on
the caller ID. If the caller ID does not match a specified pattern,
access is rejected, regardless of the authentication method.
This comparison is applied before the access list is applied. If
this parameter is blank (not specified), all callers are
considered for VoIP service.
• Use ? to match any single digit.
• Use * to match any number of digits.
Example: 1408*, 1512???1234
In the above example, the caller ID either must start with 1408
or must be an 11-digit numbering starting with 1512 and
ending with 1234.
Default setting: blank
6
123