Table of Contents
Advertisement
VIDEOJET decoder 7000
4
Installation
4.1
Preparations
The decoder and the power supply unit are both intended for use indoors only. Select a
suitable location for installation that guarantees to meet the environmental conditions.
Notice!
The ambient temperature for the unit must be between 0 and +40 °C (+32 and +104 °F). The
relative humidity must not exceed 90%.
The unit and the power supply unit generate heat during operation, so you should ensure that
there is adequate ventilation and enough clearance between both units and heat-sensitive
objects or equipment. Please note the maximum heat value of 460 BTU/h per unit without the
power supply.
Please ensure the following installation conditions:
–
–
–
–
–
–
–
4.2
Mounting
VESA
The decoder comes with four stands. Place the unit upon an appropriate flat surface from
which it cannot fall down.
As an alternative, you can mount the decoder to an approved monitor using the supplied
mounting kit.
Caution!
Injuries by falling equipment
!
The mounting location must be able to reliably hold the unit. The load-bearing capacity must
be adequate for four times the weight of the unit.
If mounting the unit to the back of a monitor, use only monitors with standard VESA mount.
Bosch Securtity Systems B.V.
Do not install the unit or the power supply unit close to heaters or other heat sources.
Avoid locations exposed to direct sunlight.
All ventilation openings must be kept free from blockings. Do not stack several units one
on top of each other.
Allow sufficient space for running cables.
Ensure that both the unit and the power supply unit have adequate ventilation. Bear the
total heat output in mind, particularly when installing multiple units in a switch cabinet.
When making connections, use only the cables supplied or use appropriate cables
immune to electromagnetic interference.
Position and run all cables so that they are protected from damage, and provide adequate
cable strain relief where needed.
Avoid impacts, blows, and severe vibrations that exceed the specification limits, as these
can irreparably damage the unit.
VESA
VESA
Installation manual
Installation | en
VESA
A
A
A
A
2019.10 | v01 | F.01U.345.382
11
B
B
B
B
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the VIDEOJET decoder 7000 and is the answer not in the manual?
Questions and answers
Good day, I have Videojet decoder 7513 in my location, however this even though it's on the network with my BVMS I cannot add it to the BVMS. 1. I tried the scan for Decoder option in the config client, yet the device could not be located. 2. When i ping the decoder IP address i get a "destination unreachable" reply 3. I also discover that on directly connecting a monitor to the decoder, there was image on the screen. please I need urgent assistance to resolve this issue Thank you.