Restore Default Settings - Crestron UPX-2 Operation Manual

Crestron UPX-2
Strip and Tin Wire
Add Hubs
68 ¥ Universal Presentation Processor: UPX-2
When daisy-chaining Cresnet units, strip the ends of the wires carefully to avoid
nicking the conductors. Twist together the ends of the wires that share a pin on the
network connector and tin the twisted connection. Apply solder only to the ends of
the twisted wires. Avoid tinning too far up the wires or the end becomes brittle.
Insert the tinned connection into the Cresnet connector and tighten the retaining
screw. Repeat the procedure for the other three conductors.
For larger networks (i.e., greater than 28 network devices), it may become necessary
to add a Cresnet Hub/Repeater (CNXHUB) to maintain signal quality throughout the
network. Also, for networks with lengthy cable runs it may be necessary to add a
Hub/Repeater after only 20 devices.

Restore Default Settings

To restore the default settings of the UPX-2:
1. Connect to the UPX-2 as described in "Establishing Communication" on
page 58.
2. Open a console window in Crestron Toolbox and type the command
RESTORE. This command will affect the following parameters:
•
IP Table: All IP table entries are deleted.
•
Video/RGB settings: Settings are reset to "0".
•
Net ID: Reset Net ID to 03.
•
Display Output will be set to 1024 x 768.
•
Project Working Path: The Project Working Path will be set to
user\display.
•
Internet Security settings: High for Internet sites, Medium for
Intranet, Low for Trusted sites. Trusted sites list is restored to
crestron.com and 192.168.*.*.
•
Standby Timeout: Standby Timeout will be reset to 10 minutes.
•
Console settings: Restored to factory defaults (115200 Baud, no
parity, 8 data bits, 1 stop bit).
•
Mouse cursor show/hide status: Restored to factory default setting:
"Hidden".
•
Ethernet Settings: TCP/IP properties will change to DHCP.
•
Mapped Drives: All mapped drives will be cleared.
•
Admin Username and Password: Admin Username and Password
will be set to upxadmin.
•
Hostname and Workgroup name: The hostname and workgroup
name of the touchpanel will reset to their factory defaults.
CAUTION: Do not turn off power to the UPX-2 while it is restoring the
default settings. Damage may occur.
Universal Presentation Processor
Operations Guide – DOC. 6276C