Crestron UPX-2 Operation Manual page 11

Universal Presentation Processor
Operations Guide – DOC. 6276C
"Touch Screen / Console Settings" Window
3. Click Save & Reboot on the SETUP MENU. Do not click EXIT.
CAUTION: At power up or reboot, the touchpanel will cycle through
colors and the Crestron logo screen for approximately 2.5 minutes prior to
displaying the progress bar. This is a normal part of the boot up process. Do
not turn off power to the UPX-2 while it is rebooting. Damage may occur.
4. Open Crestron Toolbox and click the Address Book icon
Tools | Manage Address Book to open the Address Book. The Address
Book allows you to maintain a list of accessible control systems and
network devices. You can establish a session with any or all of the devices
in the address book (provided the PC has a valid connection to the Cresnet
or Ethernet network).
5. Select the device from the Address Book or click Add Entry and type a
name for the new device (UPX2 in our example).
6. Select RS232 as the Connection Type and select the serial settings specified
in step 2. This sets the PC to the same serial settings as the UPX-2. Enter
the settings and click OK.
For the UPX-2, the default settings are:
•
Port = COM 1
•
Baud Rate = 15200 (or select Auto-Detect)
•
Parity = None
•
Data Bits = 8
•
Stop Bits = 1
•
Hardware Handshaking (RTS/CTS) enabled
•
Software Handshaking (XON/XOFF) not enabled
Crestron UPX-2
Universal Presentation Processor: UPX-2 ¥ ix
, or select