Crestron UPX-2 Operation Manual page 48

Crestron UPX-2
Touch Screen
26 ¥ Universal Presentation Processor: UPX-2
hexadecimal number can range from 03 to FE and must correspond to the Net ID set
in the SIMPL Windows program of the Cresnet system. Matching IDs between
touchpanel and SIMPL Windows program is required if data is to be successfully
transferred. The Net ID for the UPX-2 is factory set to 03. No two devices in the
same system can have the same Net ID.
Two buttons below the hexadecimal display, UP and DOWN, increase and decrease
the CRESNET ID by one, respectively.
Select OK to accept the changes and return to the SETUP MENU.
The Touch Screen button permits you to select how to use the AUX COM serial
port. The AUX COM port can be used for serial communications between a PC and
the UPX-2 console or as a communications port between the UPX-2 and third party
touch screens. The "Touch Screen / Console Settings" window also provides Mouse
Cursor, Key Click, and touch screen calibration for both finger touch and annotation
pen.
NOTE: Touchpanel calibration may be required after a firmware upgrade.
Console Operations
To use a PC to communicate with the UPX-2, over a serial connection, you must
select Console in the upper-left corner of the "Touch Screen / Console Settings"
window. Select the console settings required to communicate with the PC.
Touch Screen/Tablet Operations
To set the AUX COM port to communicate with a third party touch screen or tablet,
rd
you must select 3 Party Touch Screen / Tablet in the upper-left corner of the
"Touch Screen / Console Settings" window.
"Touch Screen / Console Settings" Window
The UPX-2 supports Crestron DTT, CyberTouch™, Wacom™ USB, and other third
party touchpanels. Specific models and protocols are subject to verification. Refer to
the Crestron website or contact Crestron for latest device support.
Up to five touchpanels (up to four Crestron, CyberTouch, or Wacom USB
touchpanels and one third party serial touchpanel) can be connected to the UPX-2 at
one time. Only one third party touchpanel can be connected at any time. The
touchpanels can be connected to the UPX-2's four USB ports and AUX COM port
Universal Presentation Processor
Operations Guide – DOC. 6276C