Crestron UPX-2 Operation Manual page 50

Crestron UPX-2 Universal Presentation Processor
•
Press OK to accept the changes and return to the SETUP MENU.
Configuring Other Touchpanels
A variety of third party touchpanels and tablets are supported by the UPX-2. Click
Other Devices in the "Touch Screen/Console Settings" window to open the "Touch
Configuration" window for third party devices.
"Touch Configuration" Window
A device can be calibrated by selecting the device and clicking Calibrate. The
timeout (in seconds) for the calibration procedure can be adjusted from this screen by
clicking the up or down arrows next to the time value. To add a new device, click
Add... to open the "Configure Device" window.
If a device's configuration requires changes to be made, select the device and click
Modify... to open the device's "Configure Device" window.
NOTE: Only one third party touchpanel can be connected to the UPX-2 at a time.
Before adding a new third party touchpanel, the existing touchpanel entry must be
removed by clicking Remove....
"Configure Device" Window
Enter a name for the new device (or edit the existing device name) and select a
supported device-type from the Type drop-down list. If applicable, the Port field will
indicate which of the UPX-2's serial ports should be connected to the device. USB
devices can be enabled or disabled by checking or unchecking the Enable box.
NOTE: The Name which is entered for the device is for the end-user's convenience
and is displayed only during calibration.
28 ¥ Universal Presentation Processor: UPX-2
Operations Guide – DOC. 6276C