Crestron UPX-2 Operation Manual page 34

Crestron UPX-2
12 ¥ Universal Presentation Processor: UPX-2
Connectors, Controls & Indicators
# CONNECTORS
CONTROLS &
INDICATORS
1 PWR (LED and button)
2 NET LED
3 MOUSE
4 KEYBOARD
5 NET
NET
24 Y Z G
6 RESET Button
7 SETUP (LED and button)
(Continued on following page)
Universal Presentation Processor
1
, DESCRIPTION
Indicates processor is powered on and active;
Recessed pushbutton, processor
shutdown/reactivate;
Press and hold button for five seconds to shut
down the system (overrides the main off
switch on the rear). Press momentarily to
restart.
Indicates communication with Cresnet
system.
6-pin mini DIN female; PS/2
6-pin mini DIN female; PS/2
(1) 4-pin 5mm detachable terminal block;
Cresnet slave port (data only; 24V terminal
not used); Connects to Cresnet control
network.
Pin 1 (24) N/A
Pin 2 (Y) Data
Pin 3 (Z) Data
Pin 4 (G) Ground
NOTE: The UPX-2 does not use, or supply
power to the 24 VDC Cresnet connection.
NOTE: The UPX-2 is only compatible with
2-Series control systems.
(1) Recessed pushbutton, hardware/software
reset
Used to setup unit's Net ID in conjunction with
Crestron Toolbox; touch-settable ID (TSID)
Operations Guide – DOC. 6276C
®
mouse port
®
keyboard port