Calibrate The Output Display Device - Crestron UPX-2 Operation Manual

Crestron UPX-2
xii ¥ Universal Presentation Processor: UPX-2
Crestron Toolbox Address Book Setup for TCP-IP Connection
NOTE: The UPX-2 Ethernet default communication mode is DHCP. Refer
to "TCP/IP" on page 62 for Ethernet setup instructions and use the SETUP
MENU to change communication format if desired.

Calibrate the Output Display Device

Access the UPX-2 SETUP MENU as described in "Accessing the SETUP MENU"
on page vi.
Click Display Output, select the appropriate Output Resolution, and click Apply. If
the screen resolution is not acceptable, choose another resolution setting. If the
controls are not visible due to the change in resolution, use Crestron Toolbox to
change the resolution. Refer to "Display Output" on page 29 for instructions.
Select the following Test Patterns, in the following order, and adjust the display
device as necessary.
1. Grid
2. Vertical Lines
3. Color Bars
4. Grayscale Gradient
5. Frequency Adjust Test
6. Streak, Boost and Skew
7. Full Screen White
8. RGB Gradient
NOTE: If the screen does not fit properly, adjust the resolution.
Universal Presentation Processor
Operations Guide – DOC. 6276C