Crestron UPX-2 Operation Manual page 70

Crestron UPX-2
48 ¥ Universal Presentation Processor: UPX-2
NOTE: The on-screen keyboard cannot be used when the UPX-2 is in the
Annotation mode. The on-screen keyboard cannot be used with MediaMarker
Notebook.
SHUTDOWN Details
To reboot the UPX-2, press Save & Reboot, located in the SHUTDOWN section of
the SETUP MENU.
CAUTION: At power up or reboot, the touchpanel will cycle through colors and the
Crestron logo screen for approximately 2.5 minutes prior to displaying the progress
bar. This is a normal part of the boot up process. Do not turn off power to the UPX-2
while it is rebooting. Damage may occur.
To turn off the UPX-2, press Shut Down, located in the SHUTDOWN section of the
SETUP MENU.
CAUTION: Do not turn off power to the UPX-2 while it is shutting down. Damage
may occur.
•
The screen goes black.
•
You may see various images on the display. This may take a few minutes.
•
When a screen appears with the Windows logo that says "It is now safe to
turn off your computer", you may turn off the power.
This is the recommended method for powering down the UPX-2. After the UPX-2
has been shut down, the power cord can be safely removed from the UPX-2.
STANDBY TIMEOUT Details
The STANDBY TIMEOUT section can turn off the display outputs when the screen
has not been touched for a specified time frame (minutes). When a display is
activated, the last screen to be displayed reappears. Minutes can vary from 0 to 120,
where 0 disables the timeout. Press Up or Down to adjust the timeout period.
"Standby Timeout" Example
The timeout time of each output can be set individually by selecting the relevant
output. The timeout time of both outputs can be set simultaneously by selecting
Both. To increase the timeout period, press Up. To decrease the timeout period,
press Down.
Universal Presentation Processor
Operations Guide – DOC. 6276C