Program Checks - Crestron UPX-2 Operation Manual

Universal Presentation Processor
VisionTools Pro-e
Firmware
Cresnet Connections
Ethernet Connections
Operations Guide – DOC. 6276C
Upload the VisionTools Pro-e file to the UPX-2 using VisionTools Pro-e or Crestron
Toolbox. While the UPX-2 can use project files that are located on a removable
drive or a network drive, projects loaded with Crestron Toolbox become the default
UPX-2 project. Other UPX-2 projects can be selected from the Select Project section
of the SETUP MENU as described on page 30.
NOTE: The maximum usable project size is 190MB.
Check the Crestron website to find the latest firmware. (New users may be required
to register to obtain access to certain areas of the site, including the FTP site.)
NOTE: UPX-2s requiring a compact flash upgrade cannot be upgraded with the
procedures described in this section. For instructions or upgrading a compact flash
operating system, refer to the latest version of the UPX-2 1GB Memory & Operating
System Upgrade Installation Guide (Doc. 6443) or the UPX-2-4GB-MSO-2007
Memory & Operating System Upgrade Installation Guide (Doc. 6676).
NOTE: This procedure can only be used for firmware upgrades that are downloaded
from the Crestron website.
Upgrade UPX-2 firmware via Crestron Toolbox.
•
Establish communication with the UPX-2 and display the "System Info"
window.
•
Select Functions | Firmware... to upgrade the UPX-2 firmware.
CAUTION: While performing a firmware update, do not power off the
device unless it is unresponsive for an excessively long period of time (i.e.
greater than 15-20 minutes).
NOTE: UPX-2 firmware can only be downgraded to similar version
numbers (i.e., the first three digits must match). For example, 2.08.009 can
be downgraded to 2.08.006. However, 2.10 cannot be downgraded to 2.09.
NOTE: Touchpanel calibration may be required after a firmware upgrade.

Program Checks

Actions that can be performed on the UPX-2 vary depending on whether it is
connected via Cresnet or Ethernet.
For Cresnet connections, using Crestron Toolbox, display the network device tree
(Tools | Network Device Tree) to show all network devices connected to the control
system. Right-click on the UPX-2 to display actions that can be performed on the
UPX-2.
For Ethernet connections, display the "System Info" window (click the
and select the Functions menu to display actions that can be performed on the
UPX-2.
Crestron UPX-2
Universal Presentation Processor: UPX-2 ¥ 63
icon)