Tools Menu - Extron electronics Matrix 12800 Wideband video User Manual

Virtualization/Control Software, cont'd

Tools menu

Edit/View Config — Displays the Virtual Map screen, which
List Remote Keypads — Shows the status of all possible
Figure 3-18 — Remote Keypad screen
Assign Device Icons — Displays the complete set of input and output device icons.
Edit Device Palette — Allows you to add your own device icon graphics.
RGB Delay settings — Displays the RGB Delay & Mute Adjust screen, from which
Audio Gain settings — Displays the audio gain level setting for a single input or
Mute-Outputs settings — Displays the RGB Delay & Mute Adjust screen, from
View Input Frequencies — Displays the input horizontal and vertical frequencies
Upgrade System — Starts the system upgrade wizard, which takes you through
IP options
HTML file manager
Name Presets — Allows you to assign a name to each of the 32 global presets.
Show RS-232 Strings — Displays the ASCII commands that are used by the current
Initialize — Initializes and clears any or all of the following: ties, presets, audio
3-28 Matrix 12800 Switchers • Virtualization/Control Software
graphically presents the virtual map and allows you to
make changes to the map.
MKP 1200 Remote Keypads. Information displayed
includes: address, mode, parameter, model and firmware
version (figure 3-18). To configure a keypad, select it,
click the Reconfigure Keypad button. Use the Mode
drop-down box to select Output mode, Global Preset
mode, or Room Preset mode. Use the Output # drop-
down box to change the output number. See the
MKP 1200 User Guide, for details.
You can drag any of these icons to the input and output boxes.
you can view and adjust the switching interval setting for each input.
for all inputs and allows you to change it.
which you can mute video, audio, or both for each input.
for each input (DSVP).
the steps to save the current Matrix 12800 settings to the hard drive of the
controlling computer before you revirtualize your system.
— Allows you to set IP options (see
page 3-23).
—
Displays a list of HTML files installed on the switcher and
allows you to upload custom files from a PC connected to the switcher
configuration. You can refer to these commands for RS-232 programming.
configuration, preset titles, icon names, and icons.
"Ethernet protocol settings" on
.