Table of Contents
Advertisement
Setting the default audio gain
By default, the audio gain of each output is set to 0 dB (unbalanced) and
6 dB (balanced). You can reduce this setting by 6 dB (-6 dB [unbalanced],
0 dB [balanced]). Change the audio gain for one or more outputs as follows:
C
N Remove two cards for a stereo output and one card of a mono output.
1.
Use the table below and figure 6-15 on page 6-17 to identify the cards for the
output to be set.
Output
1 - 16
16 - 32
33 - 48
49 - 64
65- 80
81 - 96
97 - 112
113 - 128
C
N The audio output cards are the longer cards in the bottom row, inside the I/O
cardcage door of an audio BME.
2.
Remove the audio output cards from the card. See
on the previous page. Place the removed card on an anti-static surface with
the jumpers facing up.
N The audio cards are shipped without jumpers. Jumpers are available using
Extron part # 10-076-10.
Do not touch the electronic components or the connectors on the backplane
or on the circuit cards without being electrically grounded. Handle circuit
cards by their edges only. ESD can damage ICs, even if you cannot feel,
see, or hear it.
Output cards (stereo)
Left 1, Right 1
Left 2, Right 2
Left 3, Right 3
Left 4, Right 4
Left 5, Right 5
Left 6, Right 6
Left 7, Right 7
Left 8, Right 8
Do not touch the electronic components or the connectors on the backplane
or on the circuit cards without being electrically grounded. Handle circuit
cards by their edges only. ESD can damage ICs, even if you cannot feel,
see, or hear it.
Matrix 12800 Switchers • Upgrades and Maintenance
Output card (mono)
Left 1
Left 2
Lef 3t
Left 4
Left 5
Left 6
Left 7
Left 8
"Removing the I/O
card",
6-19
Advertisement
Table of Contents
