Extron electronics Matrix 12800 Wideband video User Manual page 75

Programming Guide, cont'd
Command and response table for SIS commands (continued)
Command
Create and recall presets
N • If you try to recall a preset that is not saved, the matrix switcher responds with the error code E11.
• If you try to save a preset for a room that has not been created, the matrix switcher responds with the error code E21.
• Outputs must be assigned to a room before a room preset can be created.
• The following characters are invalid or not recommended in preset names: + ~ , @ = ' [ ] { } < > ' " ; : | \ and ?.
Save current the current
configuration as a global
preset
Example:
Direct write process —
N The direct write of a global preset should always be preceded by a clear global preset ties command of that same
preset number, as shown below. In a directly-written preset, the input tied to each output position (or no tied input)
remains unchanged unless overwritten or cleared.
If you do not clear the ties in a global preset number before you directly write a global preset to that number, ties that
are part of the previous version of the specified preset with the same number can unexpectedly become part of the newly-
created preset.
Clear a global preset ties
Directly write a global
preset
Example:
Recall a global preset
Example:
Write room outputs
• Outputs must be assigned to a room before a room preset can be created.
N
• A room can contain a maximum of 16 outputs.
• An output can belong to only one room.
• The maximum number of rooms (
• If no room name is assigned, the default name is "Room #
Example:
X(
N = Preset number
X!
= Input number
X@
= Output number
X1)
= Room number
4-10 Matrix 12800 Switchers • Programming Guide
ASCII command
(host to switcher)
X(
,
9,
E X1) }
+ P0*!
E X( X! X@ X! X@
+ P * !... * $
E }
+27P0*!
+27P22*5!15*29$13*26%3*8&
Esc
X(
.
5.
EX1) , X@ , X@ X@ }
,
... MR
1 2 n
X1)
s) is 32.
E }
, , , ,
8 3 04 5 6MR
01 – 64
000 – maximum number of inputs (000 = untied)
001 – maximum number of outputs
00 – 32
Response Additional
description
(switcher to host)
X(]
Command character is a
Spr
comma.
]
Save current ties as preset 9.
Spr09
X1)]
Spr Clear all ties in preset
X(]
You can enter as many
Spr
ties as are valid for your
virtualization. Tie all (!), tie
RGBHV (&), tie video (%),
and tie audio ($) commands
are all valid.
]
Clear all ties in preset 27.
Spr27
Brackets are shown to separate
ties for clarity only. Create
]
Spr27
global preset 27, which ties
video and audio input 22 to
output 5, RGBHV input 15 to
output 29, video input 13 to
output 26, and audio input 3
to output 8.
X(]
Command character is a
Rpr
period.
]
Recall preset 5, which
Rpr05
becomes the current
configuration.
See notes.
X1) X@ , X@ X@ ]
,
Mpr , ...
1 2 n
X1) X@ X@ X@
• ,• ,• ".
1 2 3
]
, , , , Outputs 3, 4, 5, and 6 are
Mpr8 003 004 005 006
assigned to room 8.
X1)
.