Getting A Dhcp Ip Address - AMX Enova DGX 8 Instruction Manual

Getting a DHCP IP Address

By default, the WebConsole is set to use a DHCP (Dynamic Host Configuration Protocol) IP address (a connection must
be established with a network that contains a DHCP server).
If the IP address has been changed to a static IP address and you want to change back to a DHCP IP address, use the
following directions.
To force invocation of a DHCP IP address:
1.
From the Devices drop-down list in the upper right-hand corner, select NI Master.
The Network Settings page opens.
FIG. 85
Network Settings page
2.
If DHCP is not selected under IP Address, click to enable.
3.
Click Accept.
4.
Click Reboot. The WebConsole begins searching for a DHCP server.
If the search times out, the address will revert to the previous IP address.
Important: Any time you click "Reboot" from any page in the WebConsole, the server reboots. The reboot
updates information between the Enova DGX Master and the server. The Enova DGX Switcher itself does not
reboot.
Instruction Manual – Enova DGX 8/16/32/64 Digital Media Switchers
NetLinx® Integrated Control
DHCP
148