AMX Enova DGX 8 Instruction Manual page 50

Important: Because the LAN 100/1000 port is the single, shared connection to the LAN for all connected
DXLink Transmitters and Receivers, if the LAN port on the transmitters and receivers will be used for network
connectivity, a Gigabit (1000 Mbps) LAN connection between the network and the Enova DGX Switcher's
LAN port is strongly recommended. Lower speed connections may result in inferior performance of the
embedded Ethernet network.
The two small rectangular LEDs on the RJ-45 connector indicate the following:


IP Protocols Used by the Enova DGX Integrated Controller
IP Protocols Used by the Integrated Controller
Protocol
FTP
SSH
Telnet
HTTP
HTTPS/
SSL
ICSP
Instruction Manual – Enova DGX 8/16/32/64 Digital Media Switchers
Green L/A LED
On – Link is active (when the Ethernet cable is connected and terminated correctly)
Yellow SPD LED
On – receiving or transmitting LAN data packets
The integrated Master has a built-in FTP server
The SSH port functions using the same interface as Telnet but over a secure shell
where it uses SSL as a mechanism to configure and diagnose a NetLinx system. This
port value is used for secure Telnet communication.
Note: Only SSH version 2 is supported.
The NetLinx Telnet server provides a mechanism to configure and diagnose a
NetLinx system. For maximum flexibility, the Master can be configured to use a
different port than 23 or disable Telnet completely from either Telnet or the Program
port on the rear of the Enova DGX Switcher. Once disabled, the only way to enable
Telnet again is from the Program port.
The integrated Master has a built-in web server that complies with the HTTP 1.0
specification and supports all of the required features of HTTP v1.1. This port is used
for unsecured HTTP Internet communication between the web browser's UI and the
integrated Master.
This port is used by a web browser for secure communication between the web
server UI and the integrated Master. This port is also used for simultaneous
encryption of this data, using the SSL certificate information on the Master as a key.
The port is used for peer-to-peer protocol for both Master-to-Master and Master-to-
device communications. This type of communication is used by various AMX
products for communication among themselves (see page 166).
Note: The integrated Master can only be configured to use Port 1319, and the ICSP
cannot be disabled.
Description
Installation and Setup
Standard Port #
21/20 (TCP)
22 (TCP)
23 (TCP)
80 (TCP)
443 (TCP)
1319 (UDP/TCP)
50