AMX Enova DGX 8 Instruction Manual page 41

Enova DGX 64
The Enova DGX 64 has input boards at the top of the enclosure's rear and output boards below.


Input connectors
Output connectors
FIG. 21
Numbering on numbering plate indicate input and output board channels
Cabling Specific Connector Types
For information on board connectors and cabling and specifications for specific types of connectors:





Input and Output Signal Cables
Caution: If you are connecting switching systems via their DXLink ports (applies to DXLink Twisted Pair and
DXLink Fiber Boards), be sure to read the information on page 94 (DXLink Twisted Pair) and on page 106
(DXLink Fiber).
If using cable management bars, install them before attaching the cables (see page 39).
Before connecting all of the input and output cables and wires, attach only the ones for the first two sources and
destinations (and any applicable transmitters and receivers). Complete the remaining installation tasks (applying power
and any system setup though NetLinx Studio), and then disconnect the factory default switch and execute a test switch
(see page 56). When the test switch is successful, attach the remaining input and output cables and wires.
Instruction Manual – Enova DGX 8/16/32/64 Digital Media Switchers
Enclosures have 32 horizontal board slots (16 slots each for the input and the output boards, with 4 connectors
per board), allowing for a maximum configuration of 64x64 (FIG. 12 on page 21).
Input and output channel numbers correspond to the connectors and are located in the middle of the
enclosure between boards on either side. For inputs, numbering is consecutive from left to right on
each board from the top input board on the left to the bottom input board on the left, continuing on the
top input board on the right to the bottom input board on the right.
the same pattern.
HDMI Boards – page 70
DVI Boards – page 79
DXLink Twisted Pair Boards – page 84
DXLink Fiber Boards – page 99
DGX SC Optical Boards – page 114
Input connectors
Output connectors
Installation and Setup
Outputs start over at "1" and follow
Numbering plate
41