AMX Enova DGX 8 Instruction Manual page 221

13.
Attach cables to the board's connectors* and reconnect any other cables that were disconnected in Step 4
(if applicable – tie cables to cable management bars).
If the enclosure is not powered down:


14.
If the enclosure was powered down – Reapply power.
15.
Optional – If you have custom board settings to load to the board, use DGX Configuration Software to load them
now (see page 172).
16.
Execute a test switch using a connection on the new board to be sure that video is present at the destination
(Control Panel: press Function Key, Select Key, Input Key, Output Key, and Take Key).



If the test switch does not work, see "Board Troubleshooting" on the next page.
17.
Enova DGX 32 only – Replace the connector numbering plate that was removed in Step 2.
* If you need cabling information, see the specific board chapter in this manual.
Important: If for any reason a board slot is left empty, be sure to attach a blank plate to cover it.
Additional Board Information
HDMI and DVI Boards
If the boards do not have custom settings, they will default to the Scaler mode of "Auto" and an override resolution of
1280x1024. If necessary, DGX Configuration Software is available for configuring these boards (see page 172). DGX
Configuration Software is available at www.amx.com.
DXLink Twisted Pair Boards
For information on DXLink Boards and system setup with DXLink Transmitters and Receivers, see page 90.
DXLink Fiber Boards, Duplex
For information on DXLink Fiber Boards and system setup with DXLink Fiber Transmitters and Receivers, see page 99.
SC Optical Boards
For information on SC Optical Boards and system setup with DGX Fiber Modules, see page 116.
Audio Insert/Extract Board
For compete information on the Audio Insert/Extract Board, see page 119.
Instruction Manual – Enova DGX 8/16/32/64 Digital Media Switchers
For connecting an SC Optical Input Board – Avoid direct eye exposure as you (a) remove the dust plugs
from the SC fiber connectors on the board, (b) remove the dust caps from the fiber cables, (c) establish the
connections, and (d) apply power to the DGX TX Modules that are connected to the inputs.
For connecting an SC Optical Output Board – Avoid direct eye exposure as you (a) remove the dust plugs
from the SC fiber connectors on the board, (b) remove the dust caps from the fiber cables, and
(c) establish the connections.
Additional testing for Audio Insert/Extract Board functionality:
Insert function – If the DIP switch for the audio connector is set to insert, the video signal from the
corresponding video input or output will carry the inserted audio; check that the inserted audio is present
with the display.
Extract function – If the DIP switch for the audio connector is set to extract, the audio will be extracted
from the corresponding video input or output signal; check the auxiliary or supplemental audio equipment
involved to be sure the extracted audio signal is present where expected.
Appendix E – Adding or Replacing Boards
221