Attaching Video Input And Output Cables - AMX Enova DGX 8 Instruction Manual

Attaching Video Input and Output Cables

Input and output connectors are the attachment points for source and destination devices that connect to the system.
Enova DGX 8/16
Viewed from the rear of the enclosure, the Enova DGX 8/16 input boards (for attaching sources) are on the left, and the
output boards (for attaching destinations) are on the right.



FIG. 19
Numbering on numbering plate indicate input and output board channels (Enova DGX 16 shown)
Enova DGX 32
Viewed from the rear of the enclosure, the Enova DGX 32 input boards (for attaching sources) are on the left, and the
output boards (for attaching destinations) are on the right.


<------Input connectors------>
FIG. 20
Numbers on numbering plate indicate input and output board channels
Instruction Manual – Enova DGX 8/16/32/64 Digital Media Switchers
Enova DGX 8 – Enclosures have 4 horizontal board slots (2 slots each for the input and the output boards,
with 4 connectors per board), allowing for a maximum configuration of 8x8.
Enova DGX 16 – Enclosures have 8 horizontal board slots (4 slots each for the input and the output boards,
with 4 connectors per board), allowing for a maximum configuration of 16x16 (FIG. 19).
Input and output channel numbers correspond to the connectors and are located between the input and output
boards. For inputs, numbering is consecutive from left to right on each board from the top board to the
bottom one; outputs start over at "1" and follow the same pattern.
Input connectors
Enclosures have 16 vertical board slots (8 slots each for the input and the output boards, with 4 connectors per
board), allowing for a maximum configuration of 32x32 (FIG. 20).
Input and output channel numbers correspond to the connectors and are located on the numbering plate (metal
strip) directly above the boards. For inputs, numbering is consecutive from top to bottom on each board
from the left board to right one; outputs start over at "1" and follow the same pattern.
<-----Output connectors----->
Output connectors
Installation and Setup
Numbering plate
Numbering plate
40