Backend Commands; Changing The Login Password; Obtaining The Hub's Ip Address Via The Command Line; Checking Port Details - AMX endeleo UDM 1604 User Manual

Section 7
Advanced Administration
7.6

Backend commands

In case of human error the Command Line can be used to perform
several Administrative tasks on the multi format video hub.
7.6.1

Changing the login password

7.6.2

Obtaining the Hub's IP address via the Command Line

7.6.3

Checking port details

Port details (resolution, port firmware) can be checked via the
command line also.

7.6.3.1 Multi format inputs

The multi format inputs located at the rear of the Hub are numbered
129 through to 132 for administrative purposes.
(1) Create a hyperterminal session with the UDM hub
using default serial connections.
(2) To change the password enter the original password
and new password separated by a full colon at the
login prompt. For Example type in admin:endeleo
at the login prompt, to change the password from
admin to endeleo.
(3) Reset the Hub. A power off then on is now required.
(1) Type i at the command prompt. Push enter.
Figure 7-3: Issuing the i command
Multi format inputs
Input
A
B
C
D
Input Number
129
130
131
132
UDM1604-USG – 2.0 - 0606 7-5