Locating The Ip Address Of The Dvx; General Options - AMX Enova DVX-3150HD-SP Instruction Manual

Perform these steps to access the configuration settings:
1. Open a web browser.
2. Enter the IP address of the All-In-One Presentation Switcher in the location bar of the web browser. (If you do not know your
switcher's IP address, see the Locating the IP Address of the DVX section on page 60.) The Main WebControl page opens
(FIG. 64).
NOTE: WebControl requires that you install the latest version of the Adobe Flash Player plug-in for your browser. If your browser does
not have the Flash Player plug-in installed, you will be prompted to install it.
3. Use the Device options menu at the top of the screen to select the <DEVICE #> - DVX-315xHD-x Switch Device. (Substitute
the model number of your unit for x.) The Enova DVX Setup page opens (FIG. 66).
If a web browser or Flash Player is not available, the All-In-One Presentation Switcher's front panel and NetLinx commands
provide equivalent controls for audio/video configuration. See the Using the Front Panel Buttons section on page 52 for more
information.

Locating the IP Address of the DVX

Locate the IP address of the DVX by using the buttons on the front panel of the unit. The IP address appears on the LCD display on
the front panel of the DVX. Perform these steps to locate the IP address of the unit:
1. Press the STATUS button on the front panel of the unit. The Status menu appears on the LCD display.
2. Use the UP and DOWN navigational arrow buttons to navigate through the options until you locate the All-In-One
Presentation Switcher's IP address. Note the IP address for future reference.
NOTE: You can use the Status Menu to verify current TCP/IP settings using the UP and DOWN navigational buttons.

General Options

The WebConsole Configuration page contains settings that are accessible from each tab. FIG. 65 indicates the universally
accessible options available on the web pages.
WebConsole Configuration Page
FIG. 65
NOTE: The number of available video and audio inputs and outputs vary depending upon which DVX model you are conf iguring.
The following table lists the general options for the WebConsole Configuration page:
General Options
Mute
Amp Volume
Refresh
Reset to Defaults
Enova DVX-315xHD & DVX-215xHD All-in-One Presentation Switchers - Instruction Manual
Reset to Defaults
Turns off the audio for the device.
Sets the output volume.
Click to reload all settings.
Click to reset the current page's settings to its factory default.
Audio/Video Configuration
Amp Volume and Mute
Refresh
60