AMX Enova DGX 8 Instruction Manual page 55

To test the connection / open the WebConsole interface:
1.
Right-click on the IP address for the Enova DGX Switcher.
2.
From the context sensitive menu, select Launch Web Control Page via Default Browser.
Tip: To access the WebConsole interface after initial setup, simply type the IP address In the address bar of
the browser and press Enter.
If the WebConsole interface does not open, see the "NetLinx WebConsole Troubleshooting" below.
WebConsole Related Topics




NetLinx WebConsole Troubleshooting
Check the following:
All power, signal, and link connections on all of the equipment.
LED indicators for the LAN 100/1000 connector on the rear of the Enova DGX Switcher.
If the LED indicators are not illuminated, check the cable type to make sure it meets cable requirements
Ping the system, i.e., at the DOS prompt enter: ping XXX.XXX.XXX.XXX
Try the following:
Try connecting to the WebConsole interface again.
If the WebConsole interface still does not open, you may need to add an exception in the Proxy Setting dialog
If problems persist, contact technical support (see page 69).
Instruction Manual – Enova DGX 8/16/32/64 Digital Media Switchers
The "NetLinx Integrated Control" chapter covers information on settings for using DHCP and static IP
address for the WebConsole (see page 146).
The "Enova DGX WebConsole Interface" chapter contains information for using the XBar Controller, a
graphic interface control panel with crosspoints for executing and disconnecting switches (see page 151).
The "Firmware Upgrade & Info for Network Admin" chapter covers the topics of upgrading the firmware,
embedding the XBar applet, and changing the proxy setting (see page 159).
Complete information for the integrated NetLinx Master (NI-3100 Class Controller) is documented in the
WebConsole & Programming Guide – NetLinx Integrated Controllers at www.amx.com.
(see page 47).
(where XXX.XXX.XXX.XXX is the WebConsole interface IP address).
box (see page 163).
Installation and Setup
Select to open
via Default Browser
55