Table of Contents
Advertisement
Network Port (RJ45)
The RJ45 Network port on the rear panel of the UDM-1604C provides 10 BaseT network connectivity.
Pinout Configuration
The following table lists the pinouts, signals, and pairing for the Network port.
RJ45 Network Port Pinouts and Signals
Pin
Signals
1
2
3
4
no connection
5
no connection
6
7
no connection
8
no connection
FIG. 9 diagrams the pinouts and signals for the Network RJ45 connector and cable.
FIG. 9
RJ45 wiring diagram
Consult the Network Administrator for correct cabling from the UDM-1604C onto the
network. For remote connectivity, the Firewall may have to be configured to open port
2008 for remote connectivity over UDP
Default IP Address
The default IP address of the UDM-1604C is 192.168.0.96.
Once the UDM-1604C is switched on, use the Setup option in the UDM WebConsole to configure the
Hub's correct IP address (see the Configuration - Setup Page section on page 45).
The IP address may also be configured via the serial port (refer to the Backend Commands section on
page 99).
UDM-1604C 4x16 Multi-Format Distribution Hub
Connections
Pairing
TX +
1 --------- 1
1 --------- 2 Orange-White
TX -
2 --------- 2
RX +
3 --------- 3
3 --------- 6
4 --------- 4
5 --------- 5
RX -
6 --------- 6
7 --------- 7
8 --------- 8
Color
Orange
Green-White
Blue
Blue-White
Green
Brown-White
Brown
Wiring and Connections
11
Advertisement
Table of Contents
