Input Balance For Yuv Signals - Barco R9010100 Owner's Manual

6. Adjustment Mode
4. Adjust the red black level on a minimal value
5. Press ENTER to select.
6. Adjust the Brightness to a maximum value until there is just no green noise visible in the black areas.
7. Adjust with the ← or → cursor keys until there is no red noise visible in the black areas.
8. Adjust with the ↑ or ↓ cursor keys until there is no blue noise visible in the black areas.
9. Set the brightness back to its normal value.
PICTURE TUNING
COLOR SPACE
COLOR TEMPERATURE
GAMMA
NOISE REDUCTION
INPUT BALANCE
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-37
If one uses a gray scale pattern, the bright spots should appear in the black bar.
White balance
1. Push the cursor key ↑ or ↓ to highlight White Balance. (menu 6-39)
2. Press ENTER to select.
3. Adjust gain red to on its lowest value. Do the same for gain blue.
Adjust contrast to a maximum value until the green noise becomes visible in the white areas and return one step.
4. Adjust gain red with the ← or → cursor keys until the red noise becomes visible in the white areas and return one step.
5. Adjust gain blue with the ↑ or ↓ cursor keys until the blue noise becomes visible in the white areas and return one step.
6. Put the contrast back on its normal value.
INPUT BALANCE
WHITE BALANCE
BLACK BALANCE
DEFAULT
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Adjust red with ↑ or ↓
blue with ← or →
Menu 6-39
Select Default to return to the factory default values.
6.4.6.3

Input balance for YUV signals

How to adjust ?
1. Push the cursor key ↑ or ↓ to highlight Input balance. (menu 6-40)
2. Press ENTER to select.
The Input balance menu will be displayed. (menu 6-41)
3. Push the cursor key ↑ or ↓ to highlight Black balance.
4. Decrease the brightness a lot.
64
INPUT BALANCE
WHITE BALANCE
BLACK BALANCE
DEFAULT
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Adjust red with ↑ or ↓
blue with ← or →
Menu 6-38
R5976690 XLM H25 25/05/2009