8. SERVICE
Overview
•
Start up of the service menu
•
Identification
•
Change Projector Address – Common Address
•
Change Customer ID
•
Communication
•
Date and time setup
•
Lamp
•
Dimming-CLO
•
Thomson worldcam mode
•
Convergence
•
Reset hardware
•
Factory defaults
•
Diagnosis
8.1
Start up of the service menu
How to start up
1. Push the cursor key ↑ or ↓ to highlight Service. (menu 8-1)
2. Press ENTER to select.
The service menu will be displayed. (menu 8-2)
MAIN
Select a path from
below :
ADJUSTMENT MODE
INSTALLATION
SERVICE
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-1
8.2
Identification
What can be seen on the identification screen ?
The identification screen shows the general information of the projector.
The following items will be displayed:
•
Type of the projector.
•
Software version
•
Configuration, installation of the projector:
-
front/ceiling
-
front/table
-
rear/ceiling
-
rear/table
•
Baud rate : transfer speed for communication with a computer. The baud rate of the projector must be the same as the baud
rate of the connected computer. When there is a difference, consult 'Change Baudrate' in this chapter.
•
Text, message and bar scales can be on or off.
•
Projector serial number : indicates the fabrication number of the projector. This number can be useful when calling for technical
assistance.
R5976690 XLM H25 25/05/2009
SERVICE
IDENTIFICATION
CHANGE PROJECTOR ADDRESS
CHANGE CUSTOMER ID
COMMUNICATION
DATE AND TIME
LAMP
DIMMING/CLO
CONVERGENCE
THOMSON WORLDCAM MODE [OFF]
RESET HARDWARE
FACTORY DEFAULTS
DIAGNOSIS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-2
8. Service
103