Change Customer Id; Communication; Baud Rate Setting - Barco R9010100 Owner's Manual

Or,
enter the digits directly with the numeric keys.
SERVICE
IDENTIFICATION
CHANGE PROJECTOR ADDRESS

CHANGE CUSTOMER ID

COMMUNICATION

DATE AND TIME
LAMP
DIMMING/CLO
CONVERGENCE
THOMSON WORLDCAM MODE [OFF]
RESET HARDWARE
FACTORY DEFAULTS
DIAGNOSIS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-7
8.4 Change Customer ID
What can be done ?
A customer ID of 16 characters can be added to the identification screen. That ID can be changed in Change customer ID as part
of the Service menu.
How to change
1. Push the cursor key ↑ or ↓ to highlight Change customer ID. (menu 8-9)
2. Press ENTER to select.
The Change customer ID menu will be displayed.
The current customer ID is filled out. (menu 8-10)
3. Reprogram the ID with the cursor keys or enter numeric values with the numeric keys.
Use the ↑ or ↓ key to change the current selected character to the desired value.
Use the ← or → key to jump to another character in the string.
4. Press ENTER to confirm the changes.
Press EXIT to return without making any changes.
SERVICE
IDENTIFICATION
CHANGE PROJECTOR ADDRESS
CHANGE CUSTOMER ID
COMMUNICATION
DATE AND TIME
LAMP
DIMMING/CLO
CONVERGENCE
THOMSON WORLDCAM MODE [OFF]
RESET HARDWARE
FACTORY DEFAULTS
DIAGNOSIS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-9
8.5 Communication
Overview
•

Baud rate Setting

• Serial Interface setting
• RS422 Termination
• Network Configuration
8.5.1 Baud rate Setting
How to setup
1. Push the cursor key ↑ or ↓ to highlight Communication. (menu 8-11)
R5976690 XLM H25 25/05/2009
CHANGE PROJ. ADDRESS
PROJECTOR ADDRESS 1
COMMON ADDRESS 0
Select with ↑ or ↓
Reprogram with ←,→
<ENTER> to confirm
<EXIT> to return
Menu 8-8
CHANGE CUSTOM ID
CUSTOM ID : AAA
Reprogram with ↑ ↓ → ← or
NUMERIC KEYS
<ENTER> to confirm
<EXIT> to return
Menu 8-10
8. Service
105