Thomson Worldcam Mode - Barco R9010100 Owner's Manual

6. Press ENTER.
SERVICE
IDENTIFICATION
CHANGE PROJECTOR ADDRESS
CHANGE CUSTOMER ID
COMMUNICATION
DATE AND TIME
LAMP
DIMMING/CLO
CONVERGENCE
THOMSON WORLDCAM MODE [OFF]
RESET HARDWARE
FACTORY DEFAULTS
DIAGNOSIS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-26
Dimming/CLO
o d e [ N o r m a l ]
- C L O -
T a r g e t = 1 5 0 0 0 l m
- D i m m i n g -
S e l e c t w i t h o r
t h e n < E N T E R >
< E X I T > t o r e t u r n
Image 8-3
When Mode on [CLO], dimming value will not be taken into account. When changing this value, the new setting
will only be taken in account when toggling mode from [CLO] to [Normal].
8.9

Thomson worldcam mode

What can be done?
"Thomson worldcam mode" enables special sequences for the DMD's to support specific sources such as the Thompson Grass
Valley Worldcam. It shouldn't be used in any other circumstances as it would cause image flicker and dimmed images with normal
sources.
How to toggle?
1. Push the cursor key ↑ or ↓ to highlight Broadcast mode. (menu 8-27)
2. Press ENTER to toggle between [On] and [Off].
Broadcast mode on.
[On]
[Off] Broadcast mode off (default position)
SERVICE
IDENTIFICATION
CHANGE PROJECTOR ADDRESS
CHANGE CUSTOMER ID
COMMUNICATION
DATE AND TIME
LAMP
DIMMING/CLO
CONVERGENCE
THOMSON WORLDCAM MODE [OFF]
RESET HARDWARE
FACTORY DEFAULTS
DIAGNOSIS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-27
R5976690 XLM H25 25/05/2009
2 4 0
8. Service
111