Terminology Overview Rugged Remote Control - Barco R9010100 Owner's Manual

4.2

Terminology overview Rugged remote control

Overview
Image 4-2
Rugged remote control
No. Key name
1 STBY
2 ADJ
3 EXIT
4 TEXT
5
ENTER
6 * key
7 Function keys
8 TEXT on LED
9
PAUSE LED
10 Cursor keys
11 PAUSE
12 Address key
13 Digit buttons
R5976690 XLM H25 25/05/2009
Description
standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. When the projector is running and you want to go
to standby, press the standby key for 2 seconds.
Adjust key, to enter or exit the menus. corresponds with the Menu key on the remote control.
Press ADJ once = entering the local menus of the rugged remote control.
Press ADJ twice = entering the menus of the projector.
to leave the selected menu or item (go upwards to previous menu). Corresponds with the
BACK button on the RCU.
to des-activate or activate the on screen dialog boxes and menus.
to confirm an adjustment or selection in the MENU.
allows to recall the stored Logo (not in PiP mode)
user programmable keys with functions for direct access.
red LED to indicate the text status.
yellow LED to indicate the pause status of the projector
Cursor Keys : to make menu selections or to access the menu bar.
to stop projection for a short time, press 'PAUSE'. The image disappears but full power is
retained for immediate restarting.
to enter the address of the projector (between 0 and 9).
direct input selection.
4. Getting Started
39