Table of Contents
Advertisement
7.3.7.2 Input Balance for YUV signals
Steps to be taken for YUV
1. Is the input balance menu already activated ?
If yes, go to step 4
If no, go to step 2
2. Push the cursor key
3. Press ENTER to select.
The Input Balance menu will be displayed. (menu 7-37)
4. Push the cursor key
5. Press ENTER to select.
6. Decrease the Brightness a lot, for example to a value 50 on the barscale.
7. Adjust RED Black Balance with the cursor key
8. Adjust the BLUE Black Balance with the cursor key
9. Increase the brightness until the left bar displays approximately 50% white noise.
10.Correct Red and Blue Black Balance adjustment in such a way the blue and red noise are just visible and a small Brightness
increase maintain a grey colour.
PICTURE TUNING
COLOR TEMPERATURE
GAMMA
DECODING [EBU]
DYNAMIC COLOR DEPTH
NOISE REDUCTION
INPUT BALANCE
Select with
or
then <ENTER>
<EXIT> to return
Menu 7-36
Checking the White Balance
There is no adjustment procedure for the white balance. This menu is usefull for checking the color tracking in relation to Contrast
and Saturation adjustment, which are adjustable in this menu item.
7.4 Geometry
Overview
•
Introduction
•
Geometry start up
•
Shift
•
Size
•
Side Keystone
•
Blanking
•
Aspect Ratio
7.4.1
Introduction
Introduction
An adjustment can be done as follow :
1.
Using the cursor key to adjust
2.
Entering the value with the digit keys. Therefore, press ENTER to select the indicated value and enter the desired value with
the digit keys. Press ENTER to confirm the entered value.
R5976483 BARCOSLM R6 17092002
to highlight Input Balance. (menu 7-36)
or
to highlight Black Balance menu 7-34.
or
or
INPUT BALANCE
WHITE BALANCE
BLACK BALANCE
Select with
or
then <ENTER>
<EXIT> to return
Menu 7-37
7. Random Access Adjustment Mode
until the red noise becomes visible in the left bar.
or
until blue noise becomes visible in the left bar.
63
Advertisement
Table of Contents
