8. Service
4. Repeat the above steps for the subnet mask and the default gateway.
5. Select APPLY and press ENTER to install the entered addresses.
If a wrong value for an octet is entered, the value will jump automatically to 255.
NETWORK CONFIGURATION
DHCP [ON]
IP ADDRESS 158.150.160.200
SUBNET MASK 158.150.160.201
DEFAULT GATEWAY
158.150.300.300
MAC ADDRESS 01:01:02:DB:FF:89
APPLY
Select with ↑ or ↓
then <ENTER>
Reprogram with ↑ or ↓, ← or →
or numeric keys
'APPLY' to confirm
<EXIT> to return
Menu 8-19
8.6
Date and time setup
Why?
As the processor logged information in a file, it is very interesting to know when exactly this information was logged.
How to set up ?
1. Push the cursor key ↑ or ↓ to highlight Date and Time. (menu 8-20)
2. Press ENTER to select.
The Date and Time menu will be displayed. (menu 8-21)
The first digit will be highlighted.
3. Use the ↑ or ↓ key to change the value. Use the ← or → key to select the next digit.
4. Press ENTER to confirm the new values.
SERVICE
IDENTIFICATION
CHANGE PROJECTOR ADDRESS
CHANGE CUSTOMER ID
COMMUNICATION
DATE AND TIME
LAMP
DIMMING/CLO
CONVERGENCE
THOMSON WORLDCAM MODE [OFF]
RESET HARDWARE
FACTORY DEFAULTS
DIAGNOSIS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-20
8.7
Lamp
How to display the lamp information
1. Push the cursor key ↑ or ↓ to highlight Lamp. (menu 8-22)
2. Press ENTER to select.
108
DATE AND TIME
2001-01-29 07:12
Select with ← or →
Reprogram with ↑, ↓
<ENTER> to confirm
<EXIT> to return
Menu 8-21
R5976690 XLM H25 25/05/2009