Crosshair, Write (Old) - Barco BarcoReality SIM6 Ultra R9040150 User Manual

2. RS232 Commands

2.64 Crosshair, Write (Old)

Description
This command will draw a crosshair on the projected image, this crosshair consists of two objects which can be each a square or a
cross. (So 4 combinations are possible)
Availability
Only available on the following software versions:
• SIM6 WARP6 MKII: V2.20
• SIM6 ULTRA HB: V1.22
• SIM6 ULTRA II: V1.00
Command
Command [0]
Command [1]
Data
Data [0]
Data [1]
Data [2]
Data [3]
Data [4]
Data [5]
Data [6]
Data [7]
Data [8]
Data [9]
Data [10]
Data [11]
Example
This will draw a cursor at position (256, 256) formed by a cross: width=1 pixel, size=10 pixels and a square: size=50 pixels.
Transmit
Start
Projector Address
Command [0]
Command [1]
Data [0]
Data [1]
Data [2]
Data [3]
90
\xfa
\xda
\x04
x-position msb (position of the crosshair in pixels)
x-position lsb
y-position msb
y-position lsb
size msb (thin ... bold in pixels)
size lsb
width msb (horizontal dimension of the crosshair)
width lsb
height msb (vertical dimension of the crosshair)
height lsb
Type:
• \x00 = 2 squares
• \x01 = cross and square
• \x02 = square and cross
• \x03 = 2 crosses
\xfe
\x01
\xfa
\xda
\x04
\x01
\x00
\x01
R5976538 BARCOREALITY SIM6 ULTRA SERIES 08/06/2005