Peripheral Source, Write - Barco BarcoReality SIM6 Ultra R9040150 User Manual

2.189 Peripheral Source, Write

Description
Select a source on an external switcher that is not in direct communication with the projector (800-port not used).
Command
Command [0]
Command [1]
Data
Data [0]
Data [1]
Data [2]
The external switcher has to be connected to the projector the same way a BARCO 800 peripheral is normally
connected (see the Owner's Manual of your projector).
The source number (Data[0]) can be used to make sure the correct file is loaded.
Example
Select source 1, type ' RGB Analog Input - Separate Sync', mode 0 on a projector with address \x01.
Transmit
Start
Projector Address
Command [0]
Command [1]
Data [0]
Data [1]
Data [2]
Checksum
Stop
R5976538 BARCOREALITY SIM6 ULTRA SERIES 08/06/2005
\x33
\xff
Source Number:
•
\x01
• ...
•
\63
External Slot Type:
• \x01 = Video Input
• \x02 = S-Video Input
• \x04 = RGB Analog Input - Sync On Green
• \x05 = RGB Analog Input - Separate Sync
• \x06 = RGB3S/RG3SB Input - Sync On Green
• \x07 = RGB3S/RG3SB Input - Separate Sync
• \x08 = Component Input - Sync on Y
• \x09 = Component Input - Separate Sync
• \x10 = Component Input - Tri-Level Sync On Y
• \x11 = Component Input - Tri-Level Separate Sync
Mode:
• \x00 = H/C Composite Sync or H/C, V Horizontal,
Vertical Sync
• \x01 = H/C Composite Video
\xfe
\x01
\x33
\x80
\x7f
\x01
\x05
\x00
\x39
\xff
2. RS232 Commands
245