Replacing The Storage Tray; Installing The Storage Tray Assembly - HP B132L+ Owner's Manual

Replacing the Storage Tray

When replacing the storage tray, use the following procedure:
1 Align the pins on the back panel of the main tray with the holes on the rear of the
Figure 40
2 Lower the front of the storage and move it slightly forward to align the pins on
3 Slide the storage tray towards the rear of the main tray until the pins are fully seat-
4 Replace and tighten the storage tray retaining screw, as shown in Figure 40.
storage tray and slide the storage tray onto the pins, as shown in Figure 40.

Installing the Storage Tray Assembly

its side with the slots on the main tray, as shown in Figure 40.
ed in the main tray slots, as shown in Figure 40.
Changing Your Workstation's Hardware Configuration
Installing Storage Devices
Retaining Screw
133